"Cab Off"-Option for Direct Output

I'd like to hook up the Kemper with a stereo power amp which is connected to two guitar cabinets. Therefore I need to enable the "Cab Off"-option of the for both outputs (Monitor Output and Direct Output). Unfortunately at the moment this is only possible for the Monitor Output.

So basically the "Cab Off"-option from the Monitor Output is needed for the Direct Output.

Quote from alwainwright

Is it fair to say you still want the cab on for the Main output?

Yes, exactly.

Quote from Ingolf

Welcome.
This has been requested before but is not going to happen.

Why not? Can you give the link to the thread in which this feature was requested before, please?

Quote from Ingolf

I cannot find the link right now but I remember it well because I requested this myself.
The reason why it's not happening is because cabdriver is a too resource intensive feature to supply it on both outputs.

The CabDriver should not get any signal for processing when the "Cab off"-option is enabled. As I understand, it would be necessary to additionally do the effects processing for this channel while the cabinet simulation can be skipped.

So maybe we can get an official statement from the Kemper guys about this feature?