So I have a mission engineering sp1 that I had laying around and want to use it to control my volume and wah. I cannot for the life of me figure it out. I connected it to the remote pedal 3&4 with trs cables and followed the instructions that were posted in the other thread about the ep1 not working and it still doesn't want to work right. I got it to go to the wah setting (no idea how I did that) but you have to click the pedal button twice to switch to it and then when it's not on the pedal doesn't do anything any ideas on how to make this work?
Mission sp1 won't work correctly with remote
- jjcor
- Thread is marked as Resolved.
-
-
I have this same problem. I think the problem is that SP-1 has a latching switch and you would need a momentary switch with Kemper. It is a shame that you can't choose in Kemper whether to use latching or momentary.
-
Yeah I just now thought about that. I guess Im going to give in and get the kemper dedicated pedals for it.
-
Yeah I just now thought about that. I guess Im going to give in and get the kemper dedicated pedals for it.
Or, get a momentary switch for your pedal - from Mission, or on eBay.
-
Are they hard to install?
-
Never mind. I just found out they're super simple to switch over. So I went ahead and ordered the white pedal as well with the momentary kit to install in it as well! I will let you know how it all turns out! Thanks for the advice!
-
You're welcome
-
So I got the pedal switched over to momentary and I can only get it to work with the wah. So when I push the button it turns the wah on and works as it should but when I push the button again it will turn off my wah but won't control the volume. Im plugged into my remote. Is it possible to control both with one pedal?
-
-
Got it figured out. I wasn't turning the Range down to -5 for it to go all the way silent.