I'm not able to switch off the mic pre-amp on any of our boards. So would just dialing the trim knob back below unity help, and then just use the fader for volume adjustments?
Dialing down the trim pot completely attenuates the channel sensivity to line level. This should be ok then with the profiler if you make sure not to send a hotter signal than -15 dB.
Dialing down the trim pot completely attenuates the channel sensivity to line level. This should be ok then with the profiler if you make sure not to send a hotter signal than -15 dB.
Cool. I've decided to start out with my Main Out signal level locked (unlinked) at -18 or -20 (I can't remember which one I used). So hopefully this will be okay.
Cool. I've decided to start out with my Main Out signal level locked (unlinked) at -18 or -20 (I can't remember which one I used). So hopefully this will be okay.
Yeah this will be fine.
