Activate/Deactivate Effects Section with 1 Switch

Olesito · Nov 7th 2016

Hi everyone!

I was wondering, if it would be possible to activate and deactivate the full Effects section with only one switch. I need to activate an EQ, reverb and delay at the same time but I don't want to use two rigs as the amp profile would be exactly the same.

MtotheEikel · Nov 7th 2016

Which controller do you use?

Olesito · Nov 7th 2016

I'm using Behringer FCB-1010 with UnO 4 Kemper firmware. For switching the Effects section I would like to use a separate single switch though.

Ingolf · Nov 8th 2016

You can use a TS switch, plug it into te back of the Profiler and assign it to 'STOMPS'.
It then will switch all stomps at once.

Share