Posts by holyblood

Ok! thanks for the answer.
However, in my case, the spillover cuts abruptly. Is this something I can control with a setting?

Hi!

See attached file!

Limelight - 2024-03-10 00-53-07.zip

I designed the fifth slot of this performance to have massive amount of delay/reverb to spillover when I change slot/channel.

When staying at channel 5, I can hear the dly/reverb trail go as long as 20 seconds. However, when I switch to another channel (channel 3 in this case), the spillover abruptly stops after roughly 3 seconds.

Delay & Reverb are in their right effect spot. Both effect mix position is set to "pre".

In rig setting, the "spillover off" option is "disabled".

I would like to know if it's by design or if I'm missing something!

Thanks!

Thanks for your answers:

I'v reried it: +100% gives me full dry signal (no wet), -100% changes nothing.

Hi! I have a question! I'm new to using wet/dry/wet signals! I have the connection to my audio interface ready (main output L&R to DLY/REV Wet and Direct output to Mod Mono).

I have a song to play with a lot a reverb, but if I set reverb mix to 100% (wet) I still hear 100% of the the dry signal. I've found a workaround by placing the reverb effect to the MOD space but I wondered if there's something I could do without changing the reverb's place since it could keep the spillover when changing rig!

Thanks!

JoHeFi found the trouble for me, thanks!