check the value of the return level parameter in the Profiling menu. If it is set too low you will get the message.
Thanks. I was pulling hair out trying to solve this!
check the value of the return level parameter in the Profiling menu. If it is set too low you will get the message.
Thanks. I was pulling hair out trying to solve this!
Sorted. I was not aware that the output soft button brought up 9 pages, I assumed there was 1 page. After scrolling to the other pages I found the main outs disabled.
Absolute novice user but I'm getting there!
I am getting no output from the 1/4" main outputs, any obvious rookie mistakes?
I am getting output from the monitor and direct out sends and I've checked using the output soft button that the volumes are linked and display showing as volumes being up. I am using a TS not TRS 1/4" and I know the leads are OK as they are working when connected to the monitor or direct outs.
Oh and yes I've read the manual.
<edit>
Yes I am in 'Perform' mode.