Where in the signal chain is the pitch fx located?
Which Output Source is assigned to the Monitor Output?
Where in the signal chain is the pitch fx located?
Which Output Source is assigned to the Monitor Output?
Which Profiler operating system is installed?
Which Outputs set to which Output Source did you connect to your interface? Did you record the three signals simultaneously?
How do you configure your interfaces inputs? Are they all set to the same values?
Seit Version 8.7.14 ist der Output EQ am S/PDIF Ausgang nicht mehr aktiv. Bitte beachte, dass mit den Updates das Main Manual und das Addendum Manual aktualisiert wird.
stefmetal Which version exactly do you refer to? Please check on the last page of the SYSTEM menu.
Thank you.
benifin The Profiler OS is not part of the Backup. Keep the current OS on the USB stick, too.
tobias l Check out the USB audio feature available since OS version 9.0.
theplayer I can import kipr files without problems. It works with the Import Rigs function from the menu as well as drag and drop.
Please open a support ticket when the issue persists.
bylvisaker In the SYSTEM MENU on page one press Edit Owner, then change the Device Name.
jvmes13 From my experience, the fact that the noise is not present with no cable plugged into the input shows that the issue is not with the Profiler.
Please open a support ticket if you cannot find the cause of the noise.
Wie sieht die DI-Spur bei dir mit EMGs aus? Bei mir durch die Bank alles weggeclippt, selbst mit Clean Sense komplett im Minus.
Das sind die EMGs, es ist bauartbedingt. Das Clipping kannst du minimiren/eliminieren, indem du die Pickups von den Saiten weg bewegst. Siehe Punkt 1 in der liste von cschmucker
This sounds like interference from a computer or monitor.
Is the noise present when you do not connect a cable to the Input of the Profiler? Does the noise change when the guitar is connected to the Profiler, and you move the guitar (in front of the monitor or computer)?
educam98 Please open a support ticket https://www.kemper-amps.com/contact
abhijitnath Please check if an Expression Pedal is assigned to Monitor Vol. Pedal in the SYSTEM settings.
Please perform an Init Globals from the System menu, page 1. “Init Globals” resets most global parameters to their default values. This includes all System Settings. It also includes the settings in the Output Section, which is, by definition global and not Rig-specific.
The S/PDIF Input on the Profiler has always operated with the left channel only.
From the Main Manual 10.0, page 142:
The S/PDIF INPUT is typically used for reamping from an audio interface. S/PDIF signals are stereo by definition; however, only the left side is taken for reamping.
Hello mennettip , please open a support ticket.
Please include the serial number of the Profiler and a detailed description of the problem.
Thank you.
Hello willbanister, please open a support ticket.
Please include the serial number of the Profiler and a detailed description of the problem.
Thank you.
Jay Shade Use the Restore function to apply a backup to a Profiler.
MitchMalloy The UA x8p features only SPDIF optical. Maybe the coax to optical converter does not work correctly.
UzlovStas Are there any post stack effects active with raised volumes?
AdamMassacre1981 You can still send the Profiler in for an exorcism. I am quite sure that our service team will successfully catch all the gremlins that seem to haunt your device