The Bass player is using the Kemper
Trevor using a AXE FX
The Bass player is using the Kemper
Trevor using a AXE FX
Hello I had the same problem but solved it by uninstalling RM and re-installing
Latest verison.
so cool they preformed THE FISH as a tribute to Chris squire
You need to Re-calibrate the FCB1010 it will drift in its function.
when I used the fcb1010 I would allways leave some play in the heel position when calibrating.
Would like More stomp slot's Pre amp block.
There is a Direct mix parameter in the amp Block.
The wah is CC1 i be leave so you need to set FCB pedal to this.
I have the Uno for KPA chip so i dont remember to programming steps on the FCB.
I was mistaken! was hearing the Rotary effect in the Mod slot and not the flanger in the effects loop
all is well
Thank you
I tried the Init global in system menu and a restarted the kemper, I still hear the sweep of my flanger pedal when the loop is off.
I have checked the Output AddOns menu and all settings are on 0.0.
I have noticed this Also it seems the return signal is still active.
So this is good if you want delay or re-verb trails, but bad if you have noisy old analog modulation pedals.
Here's a post that will give you many answer's about there intent with the foot controller.
" Our objective is to offer maximum flexibility, so that users can select the solution that best fits their needs. For example, some users want to integrate the Kemper Profiler into a bigger MIDI environment, and therefore have very specific requirements. Consequently, we have been in touch with multiple footcontroller manufacturers, and have been cooperating with them during the development of their Kemper Profiler adaptations. "http://www.kemper-amps.com/for…pdated-on-August-2nd-20/?
Glad to see some guys changing and being more open to this idea I posted before.
http://www.kemper-amps.com/for…postID=123316&#post123316
Brower mode gives 127 switchable rigs
Performance mode gives you over 625 switchable rigs (125 banks of 5 rigs)
Leave a little play at the heel end when you calibrate the FCB the optical censer seems to drift a bit.
when using rig manager if you double click a RIG it will go into preview mode of that rig
if you just want took at the rig info in rig manager single click on a RIG