Looking at getting a controller for the kemper. I see some buzz about this controller. A few questions
1. Is there a lot of setup to make it work with kemper? What all has to be programmed? Plug and play or some ground work need to be done ?
2. What chip is needed to get maximum performance
FCB-1010 Foot Controller ( OS/Firmware UnO Revision
FCB-1010 Foot Controller ( OS/Firmware ver 2.50
3. Any detailed instruction on chip replacement and what to do after replacing it
4. Can this controller not only change profiles but also turn a stomp or effect on or off. I assume it can but has to be programmed?
5. Is there any documentation anywhere that is used when programming as a guide. Kemper midi doc and FCB 1010 Manual only?
New to midi controller programming . Any answers are much appreciated.
Just thought this pedal would be more economical than purchasing 2 mission pedals expression pedals and a board from kemper whenever it comes out.