I have a profile of the head only di thru a load box. Question is can cabinets be added to this profile? If so, does anybody have any?
Thanks
Posts by michaiel
-
-
anybody got any other Pearce amp profiles?
-
found them...Bill Ruppert & Pitch Demo Rig Packs (June & July 2013) revised
-
I am looking for the following rigs
Formant Shift Blend
Kemper Cathedral
Pearce FS 8VA
P-Tone Maj Pent CThey are listed as factory rigs here....
http://www.wikpa.org/Factory_RigsSearched on Rig Exchange and downloaded every Rig Pack, but haven't found them yet...
Someone know where these are?
thanks -
Anyone got this profile of Ty Tabor's original amp?
Strat Elite (active electronics) > Lab Series L5 > Alesis Midi Verb > Crown Power Amp > Marshall 1960 cabinet
If not can someone create this for me and I will pay for it.
thanks -
i don't know if it has been stated in this post previously, but my view point on the editor is having a rack roll into the studio and being tethered for recording and editing away from the console. I have put together a 15 cable harness with spdif, usb, xlr, etc just to make life easier when the band records. To be able to edit the KPA at the console monitor to me is invaluable. Same setups for Fractal, VG99, etc...
Yea the KPA is fairly intuitive on the front panel, but remote access is paramount as far as I am concerned. (Ever had a 200lb flight case in your way while tracking guitars? )
Just saying... -
Makes perfect sense over CAT5...thanks for the clarification
-
Did I see where up to 4 Remote Controllers can be daisy chained to one Profiler? If so how
thanks -
Ok...I give up looking... where is a link to this?
-
+1 on an editor
-
I am on it..
-
I am sure this has been discussed to death, but I was hoping someone from Kemper could update us on their pedal board that they are working on. I know it is dangerous to give us false hope on a release date, but at least let us know it is in line and maybe at what stage they have taken it to. I will purchase 2 of them immediately for my touring rig...hint, hint....I'm just saying....
-
I don't know if this has been posted yet, rig manager is ok, but how about a software GUI interface replicating the front panel or maybe something like Line 6 uses. It has been faster to edit patches with other devices for me. Anyone else onboard this idea?
-
I keep all of my profiles on the computer in the program and only load what i need for a session. That way if Rig Manager is acting up at least the profile is protected on the computer....
-
FANTASTIC PROFILES....very well recorded...so much I purchased another 3 from you today...
thanks again -
Thanks for the info...I knew about the EL34's, I was hoping someone had converted their 68 Superlead to KT88's.
-
is it this one?
UKGold 70 Super – 15 Profiles
-
THANK YOU.....uuhh....I don't see it ...direct link? I will get it now...
-
you wouldn't happen to have any marshalls with KT 88 output tubes profiled?
-
thanks for the reply...i knew I had seen it somewhere