Very nice this kit, but I would like to find a cheaper self made solution.
Lorenzo
Very nice this kit, but I would like to find a cheaper self made solution.
Lorenzo
Hi all,
I would like to modify my fcb1010 (uno4kemper chip) to be powered by the midi cable.
Moreover, I would have one only cable (a dual midi cable) can someone explain me how I have to proceed?
Thanks,
Lorenzo
problem solved,
was the led too much near the sensor, in the picture you can see the original position (right in the picture) and the correct position (left in the picture)
[Blocked Image: https://dl.dropboxusercontent.com/u/4989810/led.JPG]
Thanks for the help,
Lorenzo
Thanks for the reply, now the video is public.
I've recalibrated few times.
I will try to change the curve but as you can see in the video the pedal start to work at the end of its course.
Lorenzo
Hi all,
I've just installed the uno4kemper on my fcb1010, done the calibrating procedure.
I've a problem with the pedal, it work only at the end of its course.
Just two little video to explain better than words.
Calibrating procedure:
https://www.youtube.com/watch?v=jm0cSWGe6a8
How it works:
https://www.youtube.com/watch?v=Zb_9iLaZWJY
Hope you can help me,
Lorenzo