Posts by noamb2604

  • Left and right are not balanced!

    Well.....
    I have an issue with my kemper head.
    I use stereo configuration in every show.
    Yesterday every thing was ok.
    But tonight i had a problem:
    On of the xlr outputs (left side) is lower in volume by 5db exactly.
    Panorama is set to <0> .
    And "space" mode is off.
    Could it be a software issue
    I assume that if one of the XLR "legs" was broken, then no sound would come out of this jack at all.....
    (I use the 3.3.0 after down grading
    From 4.0.3....)
    Please help!

  • Rig manager thing.....

    i want to connect my toaster to the computer for rig manager using.
    Now here is my question, if i conect my kemper to rig manager in my computer all my sounds will be up loaded automatically to rig manager for every body to search and use?

  • Here are the bugs and gliches i found after four hours of digging in the kemper with the new 4.0.3 fm

    Here are the glitches and bugs i have found after 5 hours of digging:
    1. After saving a rig on perform mode there is a very minor digital "pop" and during that "pop", all effects trails are getting cut off.
    2. Latency on remote....It take time for the remote to switch between rigs in perform mode (all though the sound itself has no latency)
    3. Kpa Loading time from start is much much longer then then 3.3.0 fw .... 1 min & 13 sec' to be exact (don't know if it's an issue, it would be nicer if it will up load a bit quicker ...)
    4. On switch number 2 on the remote ,the upper led doesn't show that there is a morph parameter "on board" (only the lower led....)
    5. When changing between "banks" there is that " digital pop" sound...
    (Like in paragraph no' 1 ....)

  • 4.0.3 fw

    Here are the glitches and bugs i have found after 5 hours of digging:
    1. After saving a rig on perform mode there is a very minor digital "pop" and during that "pop", all effects trails are getting cut off.
    2. Latency on remote....It take time for the remote to switch between rigs in perform mode (all though the sound itself has no latency)
    3. Kpa Loading time from start is much much longer then then 3.3.0 fw .... 1 min & 13 sec' to be exact (don't know if it's an issue, it would be nicer if it will up load a bit quicker ...)
    4. On switch number 2 on the remote ,the upper led doesn't show that there is a morph parameter "on board" (only the lower led....)
    5. When changing between "banks" there is that " digital pop" sound...
    (Like in paragraph no' 1 ....)

  • 4.0.3 fw

    So......down loaded 4.0.3.
    few minor issus ,no bigie.........
    making a list of bugs which ill send to the lads at kemper on the upcomming week.