Posts by paulster44

Cool

I thought I tried that, will try again

Thanks

I've tried to morph the delay mix up .. when I "throw" it works but I'd like for it to trail when I bring the pedal back down and it doesn't.. just cut's delay (in an obvious manner)
I was wondering if anyone has any insight into how to do this.

BTW, a delay "throw" is a mix term where in a particular part of a song just for a brief moment .. maybe a word or a note, just that note is sent to a delay for dramatic purpose, then the song continues with less or no delay.

Thanks

+1 Direct Monitoring

Thanks for the replies. Food for thought.

I'm not sure if this has already been covered, didn't do my due diligence as far as thread search.

Did anyone have any experience profiling a steup that includes multiple amps mixed together? I. E. Running the guitar into two or more amps, finding a blend, mixing them together and profiling that.

Is the kemper capable of doing that or would it just "confuse" the kemper having more than one amp.

Thanks.

As previously mentioned.. Single Coil PUP (even though he used humbuckers,, he could have coil tapped them or just used a different guitar in studio.) They played through rockmans in studio and the rockman has a very specific compressor sound to it.. i believe it's optical. Chorus and/or pitch shift.

grit from tape delay as standalone saturation.

Sounds great as high end fizz blended in.

Can anyone verify that when loading a preset named "bad tape" from one of the newer delays, if you set the ms to 0 it basically goes nuts.. lots of artifacts and such.

Ive been trying to use this as an effect in the x slot for the sound of the tape grit as it adds that VanHalen fizz to the tone without having to crank highs. As a plus, it's blendable. Just can't get past the artifacts.

Thanks,
P

Is there a way that one could install a lean Rig so as the only rigs installed are the ones used in performances?

Thanks guys..
ended up picking mine up from a friend here in town.

Loving it.!

Thought about that Arie, but that would mean no delay in my cab, as the previous poster mentioned... I could, however, use a external delay (fx loop) on the "X" slot and tap post "Mod", but that would mean I just don't use my delay slot.. drag. I guess I'll just live with the Rev in the cab. Not lugging around extra FRFR just for FX thank you.

I can understand that if I were using a FRFR onstage but sending a studio quality reverb through a marshall 1960 cab is not the same as hearing it through the mains of a large system. It just doesn't belong in a Marshall cab.. a spring reverb maybe but as I said, I really like the Verb through the mains. (FRFR)

Thanks

First off I'd like to point out that I really like the reverb in the Kemper.

That said, My Kemper is used in live situations very often. When it is, I use a cab for my monitoring purposes and send the main outs to the FOH.

I would be nice if i can send the reverb only to the FOH and not through my cab. IOW, if there would be a tap (source select) right after the Delay module, that would be great. I just find that the Hall Rev muddies things up in a cab situation yet sounds great in the Mains (Front of House).

Is this possible any other way.

Thanks,
P

got it.

Can't find it anywhere.

Hey everyone,

just about ready to pull the trigger and pick up a kemper rack..

All, you montrealers out there.. What is the best location to buy. Quickest, service,

Thanks,
p