Welcome Scott, will be nice to have you on the Kemper!
Posts by FLGator
-
-
There is one for sale in the UK, posted here a few days ago
-
-
Sent u a PM
-
I received the Early Bird email, went to the online store and successfully ordered. I'm based in the US, I paid with VISA, cost was $599, no cost for shipping and didn't try to add any tax or duties, total cost $599 - FYI. The email said it would ship in March
-
I haven't, however, I'm based in the US
-
Based on your measurements and the fact you don't have buzzing indicates you don't need to adjust the truss rod in this case. Adjusting the truss rod is actually very easy, you just need to be cautious. Lots of videos on YouTube etc., but essentially you would want to loosen the truss rod slightly first to ensure the adjusting nut isn't stuck and then adjust no more than and 1/8 to 1/4 turn before allowing the neck to settle. If you haven't done before I would NOT adjust more than 1/8 turn. With truss rods a little goes a long way. Always tune to pitch and remeasure neck relief after any adjustment.
-
I would expect to see new professional photos on the Facebook page soon given this leak
-
I suspect there will be a further tease before NAMM
-
4/64 E, 3/64 e
-
Nah, wishful thinking
-
-
I bought a used FCB1010 with an UnO4 Kemper chip. I set it up, double checked that I have MIDI cables correct but the KPA doesn't recognize it as shown on the UnO4Kemper guide (section 5 page 11).
All 10 pedals will switch rigs, but pedals 6 - 10 will not switch effects?
Anyone run into this problem? Any ideas?
-
-
Sorry guys for the newbie question but I tried to research and couldn't find an answer. I saved some rigs from the Rig Exchange to the Local Library but can't figure out how to save to my USB stick so I can save on my KPA, any help is appreciated
-
Thanks guys, it worked!
-
Yes, wiKPA asks the following when trying to create a new account:
To protect the wiki against automated account creation, we kindly ask you to answer the question that appears below (more info):
The nickname of the inventor of the Kemper Profiler on the Kemper User Forum?
in order to create the account you must answer this question? Thanks again.
-
What is Christoph Kemper's nickname to create account on wiKPA?
-
No did some research and was also looking for something that was fairly light, we'll see how it goes, if I don't like it I'll either go to a guitar cab or a different speaker
-
Hi all, I've been reading about the KPA for a while and lurking on this site to gain as much knowledge as possible. I just received my Kemper Rack and will be using it with a powered Yamaha DBR12. I'll be setting it up later today and starting the learning curve. No specific questions yet but I'm sure I will have plenty in the future, thanks in advance for suffering through another newb!