Have you enabled "Morph to Wah" in the KPA?
Seems like the pedals of the FCB1010 do not work for morphing because of the midi commands (if you use Uno4Kemper).
Have you enabled "Morph to Wah" in the KPA?
Seems like the pedals of the FCB1010 do not work for morphing because of the midi commands (if you use Uno4Kemper).
Uno4Kemper supports Morphing in principle similar to the Remote. So reading the Addendum 4.0 is helpful.
First hit of button 1 loads a Rig in its Base Sound. The next hit of the same button toggles Rig into Morph Sound, which at the beginning sounds like Base Sound until you start to edit Rig parameters. In Morph Sound all parameter changes are associated with Morph Sound, in Base Sound all parameter changes are associated with that sound. Subsequent hits of that button 1 toggle between Base Sound and Morph Sound. At the end don't forget to store Rig including Morphing before you load another Rig.
Any other MIDI users can configure a Morph Pedal (control change #11) to set up and control Morphing. Such a Morph pedal can then be leveraged to opportunistically control Wah and Pitch (read about MorphPedal to Wah and Morph pedal to Pitch).
So far, so good.
But how to use the expression pedals of the FCB1010 as "Morphing pedals"?
First problem!
I was just playing the guitar a little bit.
Then the first problem with the new firmware.
Please see attached picture!
I was just playing the guitar a little bit.
Then the first problem with the new firmware.
Please see attached picture!
Does anybody know how to use the morph function with the FCB1010?
In Performance mode, the autoload function (turning Type knob loads automaticly the desired Perfomance) is disabled after the update. How can I activate it again?
Cool!
@Monkey_Man:
You got it!
Of course it is about Michael Britt's profiles, but which one is used in a specific song, that's the question!
@JerEvil:
Nice!
Would be cool to know the profiles you used!?!
@Eltzejupp:
Yes the perfomance, but not the number!!!
Look at the picture!
Yes, this is a bug. Which Version do you use? Did you swap performances in Rig Manager before this happened?
Newest version.
And yes, I changed performances, made some new and copied some.
As you see on the attached picture: Perfomance number 104 exists twice!
Is that a bug?
First of all: thanks to paults ( paults)!
You gave me the hint to that profile and yes, it's Rupert's acoustic sim 2.
Guitar is a Les Paul!
I found this profile and I think it's very nice:
https://soundcloud.com/usersta/sound
Sounds like an acoustic guitar.
Guess what guitar I use!?!
Yes Frank, maybe I'm just too lazy!
@Ingolf:
Already supported yesterday!!!
@Sharry:
I expect the possibility to lock the switches and effects globaly.
That's all.
Exact that's the problem!
I would like to have the possibility to assign one switch to a specific effect in EVERY Performance and EVERY Rig.
(Global Assign)
If I have to reassign ALL effect switches in ALL rigs, I won't buy the Remote and will
stay with my FCB1010.
About 60 Performances with 5 rigs, each rig has 4-5 effects. No thanks, that's not very user friendly!