Content embedded from external sources will not be displayed without your consent.
Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy.
Class D power stages deliver certain power across certain loads. If you turn it to max volume on a 4 ohm cab it will try to deliver 1200 Watts exceeding the limit.
The power amp has a 6 dB boost to reach maximum 600 Watts of power. This means technically, if you limit this boost to 3 dBs or less with a 4 ohm cab it should not exceed 600 Watts. (Every 3 dB doubles the power)
I did a stress test onto poweramp section sometime ago to check mine. Put a dumb load (that could reach 1000w) and pushed It to 600w hard, monitoring via oscilloscope.
After a few minutes of work It starts to force protective shutdown and a brief clip at senoidal wave occurs. But It starts to work again almost imediatelly. It was a no audible test for sure. Don't try this at home
One performance per song, with bpm correct match and going from part A, B, C, D into each slot. Just performing original songs. Custom intelligent pitch scales are often used.
Using expression to controll EQ to simulate a moving filter, very, very interesting and fun to see people face they listen to it.
Mission (wah/volume) and Moog into expression (delay, pitch, move EQ parameters).
Content embedded from external sources will not be displayed without your consent.
Through the activation of external content, you agree that personal data may be transferred to third party platforms. We have provided more information on this in our privacy policy.
I used to carry my Whammy DT for Whammy and Drop tunes. Recently I sold It and I'm just using Tranpose. But latency and tracking aren't the same as Digitech.