Posts by masterofsound

Ok, then my setup is fine. I configured several deviced already. All good in Midi settings on GCP.

I guess somehow the 0/1 signal is not going to Kemper, when hitting the pedal 2 switch.

If someone has any ideas it would be great!!

Quote from paults

One thing to check: The Control Number change needs to be transmitted on the same MIDI channel as the PC changes that are received by the KPA.

But if i use one of the instant access buttons, the switching works. So this should not be the problem, right?

Just to make it save ... where can i check the midi channels for both changes?

Quote from drog

First enable the pedal switch #2 in the GCP. Go into edit mode, press the "pedal" button, press "select" down and press "yes" button. It should now say P2 is ON.

Connect a TS (mono) cable from out two on the EP-1 to pedal 2 input on the GCP

Now you need to decide how you want to turn on the wah. The easiest way is to just turn on an effect slot with the GCP. This will be done per each patch on the GCP, so you can assign it to a few things. But for this example it will turn on Stomp B and that is where you will put your wah effect.
-Choose the patch you want to edit on the GCP
- Hold edit button down for a few seconds
- Press the down select button until you see P2.### CTL###
This is where you need to set the CTL number to turn on/off the effect slot. Use the yes/No buttons to cycle up and down through the CTL #'s. Set the number to 018.
Hit edit button and save.
Now when you hit the button on the EP1 you will see the effect Stomp B turn on/off.

Remember you have to set it up for each patch you use on the GCP. But the good thing is that you can make it control different slots for different patches.

I hope this helps.

Cheers!

Display More

First of all: THX drog for your supply!

All things you wrote i have already done ... except of using a mono cable instead of a stereo.
I really thought this would be the final clue ...
But after changing cables and checking all settings once again, the toe switch is still not working.
I also checked if the switch itself is ok, by connecting it directly to the kamper footswitch port. all good!

Is there any system option within the kemper, that should be enabled to get the midi signal information from pedal/GCP right?

Hi everyone,

i use the GCP with the Kemper & the EP1-KP.

Everything works great except of the toe-switch within the pedal.
As far as i figured it out, i have to connect "out 2" on the EP1-KP into "pedal 2" of GCP. But when using Channel #1 and trying all the different pedal modes within the wah stomp, nothing happens.
Next i tried to take the channel where the wah stomp is ... #20 in my case ... but also not working.

Has anyone found out, how to get the toe-switch working??