Posts by drew571

great. thanks!

would it still pass signal? it just would't be balanced anymore?

Is there any advantage to using balanced trs cables between kemper and pedalboard? I was going to get a small mic snake to run between the two. it will be for input into the kemper and output from the kemper back to the pedal board for stereo effects sends and returns.

let me see if i follow, you're saying that if i want to have the send and receive signal recallable, then i can't use the aux in, the return from the external pedals would just be at one level all the time? i think i'm ok with that since I can adjust output on the external fx anyways. maybe i don't grasp the negative here. if there is something negative about it, could it be addressed in a firmware update?

maybe i'm confused, but i'm pretty sure that can be assigned as a stereo loop. i did it at one point unless i dont' knwo what i'm talking about. you can assign it to any of the buttons in the effects section, just assign a stereo external pedal to whichever slot you want and bingo.

you can send it stereo out using the monitor out with the direct out. that way you can feed your stereo delay on the kemper into a stereo reverb pedal unit or similar situation.

yes, that's where they would be connected to the KPA, but if i want those stereo FX pedals on my pedalboard and i'm going to need an audio snake between my kpa and the pedalboard, right? one channel to feed the KPA and 4 channels for the FX loop send/returns...?

ok, so the best way for me to use my stereo effects pedals on my pedal board with the kemper would probably be to have a 5 channel audio snake run between the kemper and the pedalboard? one for the output from my last mono pedal into the input of the kemper, and then two back from the kemper from the direct/monitor outs to my stereo pedals, and then the remaining two lines for the input back into the kemper. right? hope that made sense....

I'm wondering if it's possible to keep my stereo effects like big sky on my pedal board with the kemper remote and still be able to insert them in the effects loop section? Or are those 4 pedal jacks on the remote only for volume pedals, expression pedals etc... and who;e I'm at it, is there an advantage to using a kemper volume pedal bs a regular volume pedal? Thanks!

Just got my kemper a couple weeks ago and i"m still digging through the possibilities. So I really like some of the new delay options but if i want to hook it up with my big sky and get the stereo delay effects I'd have to just send the stereo output of the kemper, correct? there's no way to utilize another output other than the direct out to send the stereo delay into the big sky and the back into the kemper again with the alternate input for stereo loop?

hope this makes sense.

thanks in advance!