Hi guys,
I wondered how/if I could connect my Kemper Power Rack to a fullstack/two cabinets.
So I have a 2x12 Mesa Roadster Cab. 140W, 8 Ohm In and parallel out
Also I do have a Marshall JCM 900 1960 4x12 300W with a 4 Ohm and 16 Ohm input.
How can I connect both cabs to the Kemper at the same time? Kemper Power Amp into Mesa 8 Ohm Input --> Parallel Out to 16 Ohm Marshall Input?
Will this work in terms of impedance without causing harm to the power amp?
Thanks a lot!
My only concern about that is that I dont really know what I'll be sending to the FOH.
I mean, I dont know, if the cabinet profile is a good one. Or would it be possible to monitor the signal via headphones from the headphone out on the front?
Should I adapt the settings in the output section in any other way or will it be fine from the way they are set right from the factory preset?
Hello fellow Kemper users!
When on stage, I'd like to play my Kemper though a guitar cabinet just to get the better feeling and tone for me on stage.
Usually when I play though a cabinet, I do turn off the speaker simulation.
I wondered, if there is a way to simultaneously play though a cab AND send the signal via the main output to the soundboard.
But as I have mentioned before, when I play though a cab, I do turn off the cab simulation. Is there a way to turn on the cab simulation just for the main output ?
I dont want to send the raw amp signal to the soundboard because that obviously sounds shitty 
