Hi Don,
I tried to perform the test you suggested, that is to Neutral Profile by connecting a patch cable connecting the Send directly to the Return.
However this did not work.
I have attached 2 x photos.
Is my Profile function not working?
Thanks Tass
Thanks CaloLf & DonPetersen
I have tried increasing the volume to no success.
I am using this signal chain:
PROFILER Send (out)-> amp input -> amp speaker out -> cabinet(in) -> mic(cab/speaker out) -> PROFILER Return(in).
By using a patch cable, I assume you mean to use a short as possible mic cable from the mic to the Profiler Return.
I will try this tomorrow.
Hi Kemper lovers, I am getting the following error message.
“Error No external amp connected or volume too low. Please check & restart profiling”.
After attempting to profile my amp & cab, I get the above error message.
I am attempting to profile my Marshall JCM 800 2210 Lead series & my 1960A cab. I am following the instructions in the Kemper main manual 7.0 pg 277. I’m plugging straight into the Kemper as I am choosing a clean sound to profile, no effects. I am miking my 1960A cabinet connected to my Marshall head. I am connecting the Main Outs from the rear of the Kemper to my mixing desk .
Can someone steer me in the right direction?
(Also, do I have to monitor the mix by using a mixer or can i make the profile without a mixer)
