FCB1010 (UNO v1.1) Performance mode problem (SOLVED)

    I'm trying to use my FCB1010 in performance mode for the first time and I cannot get it to switch to slots 3-5 using buttons 3, 4, and 5. Each time any of those buttons are pressed the rig selection defaults to slot one. Button 2/Slot 2 work fine. Am I an idiot and doing something wrong? I've tried a factory reset of the UNO. Thanks for any help.


    EDIT: SOLVED: Several Resets and reseating the chip did the trick apparently.

    Edited once, last by amaziad ().

    I am also new to the Kemper baugt a old used FCB1010, and, ordered the uno4kemper, installed it and all functions was ok stright away! only the pedals needed to be calibrated! all efects controlled with the upper row, and presets controlled with the lower row! banks up/down