Hi!
when I use the FX Loop (both mono and stereo; pre and post Stack) turning the slot on is immediate. but when I turn the slot off the incoming signal (delay in my case) is cut off immediately, but the direct out is still sending signal for about 3 more seconds.
Is that normal or am I doing something wrong.
Direct output is set to "off" in the output section.
To anticipate the question: Why do you care? if the incoming signal is cut off immediately everything is fine!
If you feed a long delay or reverb this is problematic.
Right now I tried to feed another amp from the direct out and use the FX Loop in slot D as an ampswitcher.
Happy Easter!