Hi,
I am using the looper more now...
Yet, I cold not find a way to switch rigs without leaving the looper mode. Is there any?
Lets say I record the first loop clean, and want to add some lines with a different rig...
As far as I understand it, I have to:
0) Select clean rig
1) switch to looper mode,
2) Start recording and put down my first clean progression
3) Finish loop/stop recording (loop plays back)
4) Leave looper mode
5) change rig
6) come back to looper mode
7) Hit record and overdub (or hold "record" after recording to overdub directly (GREAT feature by the way!!!))
Is there a way to bypass 4-6?
As alternative, I was thinking about using the effect buttons... But this also lead to "step dancing" and I coulndt find a good way, yet...
All the best
EDIT: The (for me) best solution would be to be able to assaign Rogs for the effect buttons... I might also be able to work with the following solution:
1) Basic rig has no effects
2) Button I disables all adds effects (eg. transpone, for bass line
3) Button II disables all effects and activates eg. compressor/stuff
4) Button III disables all effects and activates eg. distortion pedal, ...
I just think, the needed "disable all effects" does not work... correct?