Hi, I have assigned (in browser mode) a midi PC value to a profile the way I always have in the past through the system menu on the Kemper. When I go back to the profile it shows the # I have assigned to...say [30] for example. When I send a midi command of PC #30 to the Kemper, the profiler puts up a message "unassigned program change"?
Any idea why this would be?
Thanks,
Derek
Is the PC being sent on the MIDI channel assigned in the Profiler?
Hi, yes it is....both the sending device and the profiler are set to midi channel 1.
Thanks,
Derek
check to see if your Computer/controller is set to send programs as 0 is 1 or 1 is 1
Will do, thank you
-----------------------------
FIXED - yes the PC value being sent was off by 1 so I adjusted and everything is working as expected now. Thanks for the help!
D
