Posts by reznor
-
-
You could try to place a Loop Mono in Module D, crank its Mix down, and feed the signal from the SEND (or SEND 1) into your tube amp.
But don't understand, why you don't want to use your PROFILER as your all in one device!? Just see more equipment and complexity and weight, and no value add.
Thanks, i will give that a try...didn't think to use the mix parameter...
I have non powered KPAs and instead of having to use active monitors, i like the sound of my combos that don't have FX loops unfortunately
-
Is there a way to get a post stomp/pre stack signal from one of the outputs (to the front of an tube amp) and still have the entire rig signal available for FOH of FRFR ?
Like Monitor output option "post stomp", or even better... like "Monitor cab off" - "Monitor stack off"
Thanks
-
-
Eh, if you mean you used to tweak and then save a new copy with a new name, that makes sense. If you mean you actually edited, (including renaming) and saved back to the original file, you are either delusional or need to share what you are smoking.
-
I used to tweak and rename my favorite effect presets in a way that they showed up first in the browser menu.
With 7.0 this is not possible any more, as far as i figured out....
Now i have to navigate through the whole bunch of effects to find the ones i used find to at once.
Browse by favorites would make it a lot easier!
Just my 5 cents...
-
Does the the Profiler Stage support backups from a Rack Profiler?
-
Not sure if that was requested already...but the feature of using 2 different cabs in one rig with the possibility of blending them together, just like using a head with 2 cabs, would be very nice!
-
Thank you !
-
been using RCF SMAs until now, bought one Redsound to try it out...immediately ordered a second one!
it just sounds more like a real guitar cab... -
-
what speaker model do they use?
-
-
title says it all...
makes it easier to handle different cabs,
thanks -
same here...rig manager says "updating firmware" which causes Profiler freeze
Preferences "check for updates" not flagged...
sucks... -
Instead of installing a switch in one guitar, your could put the switch in a stompbox, and ALL your guitars would have a kill switch
A single pole, single throw, normally closed switch would do it.
welcome tendinitis
-
Oh, I see, thanks. Like a VCA driven by a square wave whose freq is controlled by a pedal
ehhh... if you tell me that this is what i'm looking for... i agree
-
You do not want to control the intensity of the kill switch, do you? I te sity in this case would just be a volume control, if I get you right...
no, the speed of the toggle, like shown in that video at 1.50"
-
Display MoreWith the remote contol its easy to mute via switching to tuning. (tuning should be set to mute)
I think this function is possible with Switch/Pepal Inputs at back panel.In the reference manual I found follows:
Quote:
Instead of expression pedals, the two Switch / Pedal inputs can also be used to connect switches. Switches can be used for all kinds of tasks, such as switching effects, engaging the tuner, or tapping the tempo
Unquote:It has to be configurated in the System menue (Pedal 1,2).
I can not proof it, cause my KPA is sent to Kemper for repair.keep rockin' Harry
yep, Harry you're right !
I didn't think of muting the signal via Tuner mute !
Would you elaborate? I did not get it...
think of an extreme Tremolo effect where the speed is controlled by an expression pedal ...
-
Hi,
Anyone knows how to create a "Kill switch / Toggle switch effect" that can be controlled by an expression pedal ?
Thanks
