Posts by digbob

    At least i got the DXR 10
    DBR 10 is very leightweight
    but sounds unnatural and boomy, for guitar , its very god as PA speaker
    DXR 8 has too much Mids
    DXR 10 sounds the most natural with guitar, its a big difference to the others

    hi
    i understand this but as advice
    take one profile you like
    and play and you will know very fast that you don't have to tweak
    a lot
    good profiles let me play for hours
    without tweaking
    i only enjoy the excellent sound
    theres no need to use all these options
    but its a good feeling to have them
    which doesn't mean you HAVE to use them

    After a test with my DBR10 against a DXR 8 i prefer the DXR more, its more Guitar Amp sounding, has a bit mid scooped sound
    which fits better for Guitar i think.
    My Question is
    Is a DXR 8 enough or do i need a DXR 10 or 12
    i don't need loud levels
    th most important is that i have a Guitar Combo sounding like Speaker
    which translates the Profiles as they are made

    Hi
    just got a Yamaha DBR 10, which sounds great, is very lightweight and not expensive
    i think its pretty much the same as the DXR Modell.
    Any advice from the DXR Users how you setup your Cabinet
    means did you use the DSP switch or the Low Cut ?
    How do i get a "linear" Profile Sound out of the KPA without any coloration from the Cabinet ?

    I have both MW Britt Packs,
    they are def the best Sounding Packs for KPA,
    when you want a Amp in the Room Sound, they just work out of the box
    But as all Audio Stuff its always a matter of taste
    Def a must when you're a player with uses low gain overdrive
    and work with the Vol Control of the guitar

    You have to open the right channels in the scarlett mixer, spdif in for KPA
    and two analog ins for the Pc which you have plugged into the analog inputs
    of scarlett
    you will see the corresponding meters run
    just open this channels and route them into the monitor / headphone out
    of the scarlett mix

    Is it possible to Copy existing Folders of Rigs
    in a new Folder ?
    Ex. I have three Folders with TAF Profiles Pack 1 , 2 and 3
    I will Copy the three in a new Folder called Ampfactory
    so that the structure is
    Ampfactory,
    then inside the three Folders Pack 1,2, 3


    possible?
    I tried but can't copy cmpl Folders in a new one