I'm happy to hear. Thank you.
Posts by Woody1024
-
-
The thing is.
I've talked to support. They asked me to sent back my Kemper for repair. When I got it back, the issue was still there, so it was sent back again.
Yesterday I received a new replacement unit, but the issue is still there.
This is why I'm trying to figure out if it is a general problem or if I have been exceptionally unfortunate. -
Hello fellow Kemper users.
Do you experience the same unresponsiveness/latency when turning the knobs on your Kemper as I do?
When I turn a knob, gaps in the changing of the corresponding value appears, usually followed by a large jumps in the displayed value.
There is an example in this video clip:
https://dl.dropboxusercontent.…2/VID_20161106_162915.mp4Here is a description of what is going on in the video clip:
00:00:00 The volume knob is being turned at a steady rotation speed. After a full second the volume value jumps from 0.0 to 0.5.
00:00:03 The volume value suddenly jumps from 1.3 to 2.9. The volume knob is still being turned at a steady rotation speed.
00:00:03 The volume value gets stuck at 3.5. The volume knob is still being turned at a steady rotation speed.
00:00:04 After the volume value has been stuck at 3.5 for one and a half second, it jumps to 9.0. The volume knob is still being turned at a steady rotation speed. -
-
I bought the Till's Cablab. These are the best cab profiles I've found. They cover all my needs. Thank you Till
