Well, you guys should investigate what these interactions really do, to get the rid of the esotheric factor.
Using ONLY the power amp of the Kemper PowerRack
- AHChris
- Closed
- Thread is marked as Resolved.
-
-
Was hoping you could help ending this esotheric stuff and would share your knowledge and opinion on the matter.
-
When you make a DI profile and tap the tube power amps speaker output, while the target cabinet is the load, you can then recreate the same interactions using the internal power amp and the same cabinet.
Glad you joined this little discussion Mr Kemper
This is exactly what I was planning! This is the DI I will use for this approach http://www.thomann.de/de/count…MborpO57roCFQdY3godJlUAgA
I'll put it between amp and cab and the profile will contain the interaction between poweramp and speaker.
I'll fiddle around with this and report back
-
Don't know if this just adds to the esotheric stuff?
