Do you connect the FCB with 2 Midi cables? Check if they're connected correctly.
You need to calibrate the pedals. Check the documentation:
http://www.uno4kemper.com/UnOforKemper_manual.pdf
http://www.uno4kemper.com/cheatsheet.png
and WiKPA:
Have you checked your KPA's midi is set to either channel 1 or omni?
Latest firmware installed?
Just to check, you are using performance mode right?
Not to forget the obvious: KPA midi out goes to FCB midi in, and KPA midi in goes to FCB midi out?
sounds like a weird chip to me! mine's 5 stomps and 5 slot changes... Have you looked at the instructions and tried to make a pedal change to see how it responds?
sounds like a weird chip to me! mine's 5 stomps and 5 slot changes... Have you looked at the instructions and tried to make a pedal change to see how it responds?
if you mean holing one down for 3 seconds and then reassigning its function then yes i tried this- held it for 3 seconds and no response so looks like its a dud chip- I'm just confused as to why the fcb still changes rigs fine. its like it has been programmed with the wrong firmware- it does say uno4kemper 1.04 on the chip though.
Isn't the latest Uno4kemper version 1.2?
Are you sure you don't have the regular Uno chip? According to the Uno FAQ, the latest version of the regular Uno firmware is 1.0.4.
i will open up the fcb now and check- i did order from uno4kemper so if i have got a regular uno then they have made a mistake.
Aww, too bad. But Xavier will surely help you out quickly.
glad you figured it out!
Emailed him at lunch time- still no reply yet. Hope I can get this sorted asap. Is he usually quick at replying?
Yes, he is. I believe he has a day job and doesn't do eproms 24/7. 
