I asked in another thread but maybe noone has seen it ... so I'll try it again here:
QuoteDisplay More
I can reproduce this issue. I'm assuming, that the Eureka firmware is
sending value 1 on MIDI CC# 30 each time you hit the button. This is
sufficient to control TAP tempo, but in order to use the Beat Scanner
most effectively, the footcontroller should send 1 when you push the
button, and 0 when you release it. This way the Beat Scanner would only
be active as long as you hold the button. We are looking into this, but
our options are limited. If a footcontroller doesn't indicate a release
of a button, we cannot respond to it.
"
I'm using an ART X-15 and before 2.x software I was able to tap the
tempo with the programmed bypass switch. Now I have the same that Beat
scanner is activated.
I can turn it off with next push - But I'd rather have the tap function !.
In the X-15 manual I saw that there are several modes for bypass switch
but unfortunatly no change did bring the wished function.
There is no description for key-on and key-off so I think the unit can't do that.
Allthough in the table of modes for the bypass switch are columns "momentary" and "toggle" But like I said I tried all modes and wether no action at the KPA or Beat scanner is activated...
So there are 2 questions:
1) Could someone tell me if there is a way to programm the bypass switch
of the X-15 (or maybe another switch) to get the tap function back ?
2) Could it be that a later software version for the KPA would give the choice to get tap (like vefore) OR Beat scanner ?