Hello guys, I seem to have run into an unexpected issue. The manual states:
- Git + Processing (Not available for S/PDIF Output).Similar to “Git Analog” but AD conversion is taking place. This puts the noise gatefrom the input section and the volume pedal in the signal path (if volume pedal is setto “Pre Stomps”).Note: The volume control of the respective outputs will have no impact on the sourcesettings “Git”, because they are made to reproduce the original instrument volume.
- Git Studio Similar to “Git + Processing”, but here
I have the volume pedal configured to pre-stomps as it says, but it makes no effect on these Git output options, which will always be at highest volume no matter the pedal position. Also the Noise gate is not being put in front of these outputs (i've tested it bringing the noise gate to max value, where you can hear tonal change).
Anyone else can confirm this behavior? (I'm on latest fw 2.5.0)
Thank you guys in advice!