UnO For Kemper Perform Mode issue

Hi!

I recently got the Uno For Kemper EPROM and all works well in Browse mode, but when I go to Perform mode, nothing seems to work anymore. The FCB does not control anything. Even when I go back to Browse mode, the FCB refuses to work. Theonly thing that
The only difference I notice when switching between Browse and Perform, is that in Browse mode the Switch1 LED of the FCB is lit, while in Perform Mode it is Switch2 LED. When I go back to Browse, again Switch1 LED lights up, but FCB refuses to work.

Is there anyting that needs to be done to get the FCB to work in perform mode?

Anyone have had this before?

Sven

Hi,

thanks for the quick reply

yes, I have put 5 different rigs in the slots and can change between them on the kemper

Is there anything I am missing?

Sven

all works fine in browse mode, so full duplex should be happening,
I would assume that perform mode doesn't change anything MIDI wise?

Is there an "allow MIDI channel selection" option I need to activate?

cheers!

I know, I am trying it right now, I will record a small video later

what happens is this :

* all MIDI cables are connected properly and everything works ok in browse mode (tuner works, I can switch stomps on and off with the FCB and when done on Kemper, the FCB LEDs respond)
* when switching to perform mode, everything works fine, but as soon as I push any FCB switch 1-5 (so changing to another rig) the FCB just freezes and doesnt respond at all! After I reset the FCB (turning it off and on) everything works again, until I push any FCB switch 1-5 again, then the FCB freezes again!
Something else that is really weird, is when I press the UP switch once and let go, the FCB automatically increments all the way up to 125 and then freezes!!!

Now, I tried another FCB1010 with the UnO chip in it (my friend has a kemper as well and he brought his board and MIDI cables along) and it does the exact same thing???

Baffled...

Here is a clip I recorded of the issues

any ideas?

PROBLEM SOLVED!!!

for some reason, the MIDI channel on the KPA was set to 14
I put it to OMNI and low and behold! All ok!!!

Happy!

thanks for the help guys!!