Is it possible that rig manager changed something

Stevoe · Mar 5th 2015

I have not updated the unit or the RM and noticed that after using the RM earlier today, when I went back to me KPA without the RM it sounded kind of sterile..
Just wondering if the RM while connected to the KPA could somehow automatically change some settings... I noticed that a lot of the profiles were hissing because the noise gate seemed to be off.

not sure but maybe it did something.. riga sounded fine when browsing the RM...

steve

paults · Mar 5th 2015

Quote from Stevoe

I noticed that a lot of the profiles were hissing because the noise gate seemed to be off.

Did you change the noise gate setting?

Stevoe · Mar 5th 2015

This is what I was asking, if it was possible, because of all the recent troubles, IF this could happen without me
doing anything, only going to the RM, as I know RM sends info to the KPA, so thought maybe it sent some settings
to mine without me doing anything..:)
steve

paults · Mar 6th 2015

You are using 2.7.4 and the previous version of Rig Manager. Correct? There have been no recent issues with that release.

Have you been in the Input section recently? Is there any chance you have "unlocked" the noise gate settings in the Input section? Doing that would cause every rig to have its own noise gate setting.

deadpan · Mar 6th 2015

As strange as it I have noticed something similar to this before. I did a backup and system reset and restore. All was well. It was with an early version of rig manager.

timo · Mar 6th 2015

Quote from deadpan

As strange as it I have noticed something similar to this before. I did a backup and system reset and restore. All was well. It was with an early version of rig manager.

I don't think that Rig Manager had something to do with it.
I think you accidentally unlocked the input section. If you have a backup from that and the one you restored to, you can send it to support to check on this issue. But my bet is on an unlocked input section.

Share