Making a Profile Issue!

    I have Kemper Classic and I use Presonus Studio One Pro [S1] with Firestudio Project [FSP] interface.


    So here is what I did:
    Guitar is plugged into the kemper input
    I have output 5/6 on FSP goin to return on Kemper
    I have Direct out of Kemper going to my source amp
    I have mic going into channel 8 on FSP and set up in S1


    I hear the guitar thru the studio monitors and the amp and signal is good.


    Now I put the Kemper into Profile mode and proceed to make the profile.... it starts to make the assumed space noises and then stops with error stating amp is not conected or volume is to low!



    how can i fix this?



    TIA

    First things that come to my mind:
    - The Kemper profiles in mono, so one return from FSP is too much and maybe causes phase issues.
    - The Mic goes into ch8 on FSP, is it routed from there to output 5 on FSP? Otherwise there's no signal returning to the Kemper, only to the monitors.

    it was the return output to complete the loop!
    My first attempt is a Fishman Artist Amp with my Taylor 214CE


    plz try it its on the rig exchange serach for Fishman Artist (Acoustic) and let me know.