Firmware 3.0.1
- Turn on KPA with Remote plugged in
- Press Looper Button
- Press "5" to enter half-time mode - LED will not remain on and half-time mode cannot be engaged (Note: I've experienced very different behaviors with this at different times, sometimes engaging sometimes not . . . . . as I write this the problem exists . . . . . . now let me mess with it a bit)
- After Exiting looper mode and returning it now works and LED will engage
- Recorded longer half-time loop had fun for 5 minutes and then deleted the loop and shut looper off; switched patches around several times
- Go back into looper
- Half-time once again will not engage when hitting "5"
Intermittent problem. Software? Hardware? Please try this on yours and see if you have an issue.