Hey guys!
I just bought a Kemper Profiling PowerHead!
I would like to know how can i plug it to some active speakers (Tannoy 502).
Which connections and cables must i have to use?!? I know if i plug something wrong i can damage the equipment! 
Many thanks in advance!
Kind regards,
H.
Welcome!
Make yourself familiar with the manual.
You can use any connection to your Tannoys EXCEPT for the high voltage speaker outs.
XLR work best but when the cable length is not top long the TS connectors work just as good.
Welcome!
Make yourself familiar with the manual.
You can use any connection to your Tannoys EXCEPT for the high voltage speaker outs.
XLR work best but when the cable length is not top long the TS connectors work just as good.
You even can use the high voltage speaker out, but you have to switch off the power-amp before (soft-knob in the Output-Menu)
You even can use the high voltage speaker out, but you have to switch off the power-amp before (soft-knob in the Output-Menu)
Well, there isn't any signal coming from the speaker out if the power amp is turned off?! 
So there is no use in doing so. Besides turning the power amp on by accident will damage your active monitors!!
Better to use the Monitor out,it's just the same signal tapped out before hitting the power amp 
