Help please! IEM, cab, power head

    Hey guys,
    I'm about to play a gig with in ear monitors. I've used either monitor and main outs, same result.
    My rig is Kemper Power head, Orange 2x12 cab.
    Therefore the Cab Sim is off.
    Is there any way I can feed my IEM with the Cab On without changing the signal that goes into my cab?
    HALPPPP GUYZ

    If you're not stuck on stereo you could just send one side of Main Out to the IEM's and the other to FOH. You should set the Main Output to Master Mono in this case for the best results.

    You can send the Monitor feed into the KPA via the alternate input, mix it in with your guitar signal and monitor with IEMs via the headphone jack. Just make sure the alt input is set so it doesn't go back out to your guitar cab.


    sean