I've been successfully using an FCB1010 without any of those 3rd party firmware options with the Browser mode.
I finally decided to experiment with the Performance mode but am stuck.
Can the performance mode be used effectively with the FCB1010 without a firmware update? If so, how do you get the midi program changes to correctly pick the correct performances, etc. I programmed the pedal a number of ways but the performance mode jumped all over the place.
FCB1010 And Performance Mode
- rkaynan
- Thread is marked as Resolved.
-
-
Much work. I decided to use the uno4 kemper chip. Replaced the chip and it works like plug and play.
-
PS: I thing i have paid 16€ for it and 10 minutes to change the chip. Another 3 minutes to adjust the pedals like it is written in the Behringer manual. Quite easy.
-
+1. Programming the FCB without the UnO is a PITA.
-
I've been using the EurekaProm 2 with excellent results. Mostly working in Performance mode. Easy to set up, and lots of ways to use the FCB1010 once you have the chip installed. Makes the most sense to go with one of these solutions, so you can spend more time on the music and less on programming.