Issue at my last gig with remote

skyhighrocks · Jul 13th 2015

This is probably user error but hopefully someone can help me here....

I arranged my performances for my gig this past saturday on saturday morning...remote wasn't plugged in when I did this.

Got to my gig, powered up and while the kpa was fine, correct order for performances, the remote was still in the last order I had for my previous show. I didn't realize this until the show started. The only way I could get it right was to scroll through EVERY single performance and step on one of the buttons to bring it current. It caused a little bit of a mess because when we switched the set around halfway through the show, I couldn't find the performance for a song that was an alternate because the display was showing the old order. Got pretty frustrating....is there a way so that the remote syncs with the kpa after it boots up?

Raoul23 · Jul 13th 2015

I think this is a bug that the KPA team know about, and I'm sure a user here posted a work around for this until it's fixed in the next FW. Sorry I can't remember buddy

Ingolf · Jul 13th 2015

Yes, it's a confirmed bug and will be fixed. As a workaround for now enable 'rig autoload' and the problem will be gone.

skyhighrocks · Jul 14th 2015

Quote from Ingolf

Yes, it's a confirmed bug and will be fixed. As a workaround for now enable 'rig autoload' and the problem will be gone.

hmmm...rig autoload has always been on and it still has the same issue. Did you mean performance autoload?

Ingolf · Jul 14th 2015

Quote from skyhighrocks

hmmm...rig autoload has always been on and it still has the same issue. Did you mean performance autoload?

Yes, sorry, I meant performance autoload.

HMVMike · Jul 16th 2015

My workaround on this is to scroll through the performances on the Kemper once I've plugged in (top to bottom or bottom to top) and then it's all sorted. i've for 50 performances and it takes 30 seconds or so.

skyhighrocks · Jul 16th 2015

I tried that but I actually had to step on each preset button in order for it to sync correctly...didn't have time for that during a show. 38 performances x 5 presets=no time.

HMVMike · Jul 16th 2015

Make sure you do it on the Kemper, not the remote. It'll only take you as long as it takes to press the up/down button 38 times.

rothko61 · Jul 16th 2015

I solved this issue backing up my kpa and then restoring it.
It doesn't cost anything to try...

skyhighrocks · Jul 16th 2015

I tried that but it didn't work for me

Share