I upgraded to 3.1.2 back on the 11th of August and everything was fine. I did notice sometimes there was a noise when switching via midi but would go away after a few seconds. But just this morning the Kemper sounds like I have the cab section turned off (bee in a jar syndrome) but the cabs are on and I didn't change anything in that regard. I am running it into my studio monitors as usual. Didn't change anything. Tried unhooking the midi controller (Voodoo Labs Ground Control) and no difference even if
I rebooted the KPA. The only thing I had been doing was editing a profile and saved it and assigned the midi pc # tested it out and then everything started sounding bad
Any ideas that I can check> Should I try restoring to a previous version?
Any help would be appreciated
Dan