Use the Ripwerx software I link on this page and look at what the FCB is actually transmitting over Midi
http://el34world.com/Misc/Music/FCB_Kemper1.htm
Take a screen shot of the Midi Watch window in Ripwerx
That way we can see exactly what the FCB1010 is sending
Go to my FCB1010 UNo page here and make sure your FCB is set up correctly
http://el34world.com/Misc/Music/FCB_Kemper1.htm
Those midi commands you are showing are not what the preset pedals should be sending to change the Kemper profiles
You should see program Change numbers being sent like in the screen shot below
It looks as though your FCB is in one of the Global programming modes and not normal mode?
[Blocked Image: http://el34world.com/Misc/Music/images/ripwerx27.gif]
Thank you very much for taking your time.
Here it is. Can you see if something is wrong?
[Blocked Image: https://scontent-vie1-1.xx.fbc…ab8353bfaed1f&oe=56913A89]
https://scontent-vie1-1.xx.fbc…8315012573414195505_o.jpg
It seems that FCB want to start BiDirectional communication with the KPA but have no answer.
Try setting the global setting in ripwerx to look like this just as a test
[Blocked Image: http://el34world.com//Misc/Music/images/ripwerx33.gif]
Make sure your FCB1010 is set up for hand off sysex sendind
Look at the setup here
Receive sysex enable Procedure
http://el34world.com/Misc/Musi…1010_making_uno_ready.pdf
Hm..
Thanks again for taking your time, but it is still the same here 
I set the global setting in ripwerx to look like you said as a test and did a patch dump.
But still the same.
I noticed that the midi number in the kemper window changes as i switch the presets from the FCB board.
But only the number changes.
Im in the Browser mode of the kemper.
I can test your .syx file here and see what is going on
Can you attach your .syx file?
Attach it as a .zip file
In windows
Right click on the file and choose
Send To Compressed (zipped) folder
I was able to send your .syx to my uno 1.0.2.e FCB1010, no problem
Then I was able to get a patch dump and compare what I received to what I sent
Both send and receive files matched
I am not sure you have your settings correct
You don't need to set CNT1 and CNT2 for every preset
You have already set your stomp boxes at the top of the screen
See my screen shot - No need for the red X section
Try the .syx file I attached to this post and see what happens
Thanks for your syx file and the help.
I sent a patch dump with it but no response
I have given up and ordered Kempers remote.
It worked fine for a couple of years for cheap money.
All the best and thanks again for taking your time!
/Örjan
