Getting a fairly large volume spike whenever I turn an fx loop slot on. Is this normal? Basically makes the fx loop unusable live. Any way around this?
Volume spikes when switching FX loop on
- esotericmetal
- Thread is marked as Resolved.
-
What are you running into the FX loop? i am using a TC-Gforce, and it has quite a volumedrop, so I have to compensate for this.. It have to be set at 100% unless the sound is very bad and strange.
-
Adjust levels of pedals in the loop
-
There used to be a bug in the send return. (and before anybody says i am doing it wrong, the bug was acknowledged by the Kemper team)
To test if you are affected do this: Use the loop distortion stomp. Connect send to return with a short cable. If the spike is still there you are affected by the bug,
-
I notice if I have a loop active in a Rig and switch to it from another that does not I get a pop as well.
-
I just looked at my support mail from Kemper. Set direct out to Git+Processing and the volume spikes in the loop should go away.
-
I just looked at my support mail from Kemper. Set direct out to Git+Processing and the volume spikes in the loop should go away.
This fixed it. Thanks!
