Has anyone successfully used the Kemper to send MIDI commands to a Line 6 M13?

rmesic · May 23rd 2016

Some of the recurring requests for filters and synth blocks and volume swells etc could be done (at least for now) by controlling an effect unit in the loop through MIDI.

I plugged them in with "Out" from Kemper and "In" to Line 6, but apparently I'm not sending the correct patch change values and don't see where to set that. Hoping someone has done that already.

Andy_T-V · May 23rd 2016

From memory ... (it's a while since I used my M13) the MIDI mapping is not intuitive. I think it goes something like this:

3 - 6 - 9 - 12
2 - 5 - 8 - 11
1 - 2 - 3 - 4 (patch number with reference to buttons on M13)

with regard to sending the appropriate patch numbers see page 144 in the reference manual.

HTH

Share