Hi,
I Just downloaded the OS Update 1.0.1.
Put the KAOS.BIN file on the stick.
Put the stick in the KPA.
Confirmed update OS.
KPA starts running, then message that KPA is updating panel.
Screen flikkers several times, and turns black.
KPA is dead and can not bring it on anymore 
HELP, did I do something wrong or is there maybe something wrong with my unit or perhaps with the OS Update???
Can anyone help please?????
Regards,
Jef
Jef, have you contacted Kemper support?
try to leave it off the mains for half an hour and boot it again by holding system-button when turning on
Is it starting up and crashing or it doesn't light up at all?
Dear all,
elfredo wrote:
Quotetry to leave it off the mains for half an hour and boot it again by holding system-button when turning on
Where does this ominous half an hour come from? I had some problems with the initial release firmware 6895 where the KPA crashed and could not be rebooted at all. After disconnecting it for about twenty minutes, the reboot was successful.
At first I thought about thermal problems, because typically electronic devices do not need that long to recover (because the remaining internal charge should have disappeared after a few seconds and then the system is definitely reset).
Any convincing explanations for that long recovery period?
Best regards
DrTT
Display MoreDear all,
elfredo wrote:
Where does this ominous half an hour come from? I had some problems with the initial release firmware 6895 where the KPA crashed and could not be rebooted at all. After disconnecting it for about twenty minutes, the reboot was successful.
At first I thought about thermal problems, because typically electronic devices do not need that long to recover (because the remaining internal charge should have disappeared after a few seconds and then the system is definitely reset).
Any convincing explanations for that long recovery period?
Best regards
DrTT
Not my field, but could it be that the cache is hosted on a short time eprom with 20-30 min of battery life? After that time it resets and the bugged temporary data are canceled....
I'm really shooting in the dark....
maybe like my rme soundcard it needs a cold restart after a new istallation
don't know why. it's my electronic pendant to using a hammer 
