I would like to use a looper pedal for practising with my KPA. How can I change the position of the stereo loop. The loop ist located in front of reverb and delay. So I cannot get a dry signal from my looper. Is there a way to change the loop behind the effects?
Looper in loop
- Bluesman
- Closed
- Thread is marked as Resolved.
-
-
what about putting the looper behind the master outs?
-
I might suffer jetlag still, but I don't understand. I have a Boss RC-3 Loop Pedal and would like to connect it with the KPA so that I can let the looper run and play along. How would you connect it. If I use the stereo loop inside, I am always in front of the reverb/delay.
So what can I do? Can you describe the routing, please?Thanks - I am in Thailand now to do an overheating test
No issues yet! -
What elfredo mean is: why don't you just put the looper completely AFTER the KPA? Guitar >>> KPA >>> Looper >>> PA (or whatever you use to amplify)
-
OK - now I understand! I didn't tell you that I don't have anything to amplify at the moment. I just want to use headphones with the KPA. Then it won't work, I guess?
-
if the looper has a phone-output then it will work.
-
No - it hasn't.
-
then the only possibility i guess is to use the fx before the looper which you would place in "mod". with "x" you would have at least one stereo-effect like delay or reverb.
-
Or you get a small behringer mixer, damn cheap but good enough for this (so you can play along with backing tracks as well)
-
Did you get the Boss RC-3 to work?
I'm looking at this looper also, but usure how to get it working properly.
I'm using a XLR from KPA --> SS amp -->Speakon -->Cabinet.
anyone?