Kemper + Atomic CLR live setup question

    I just received an Atomic CLR neo and plan to use it live next week. What is the correct way to set it up during a show? I will have my XLR cable from the left mono XLR out on the Kemper to the CLR. How do I send myself out to the house pa? Is it through the link output on the CLR and if so will my signal to the house PA be affected if I turn up the master during the show?

    Hi,


    You want to take the 'Monitor Out' of the KPA into your CLR and ensure that 'Monitor Cab Off' is not selected.


    You can then take your main XLR outs to the FOH in stereo.


    I also suggest you go to the output settings and unlink the main stereo out from the master volume so that you use this to control the output of your CLR and adjust the main out levels using the soft knob if you need to. You may also want to be aware of the -12db setting on the main outs if your signal is too hot for the desk.


    As a final point I suggest you read the comprehensive manual(s) as all is explained in exquisite detail there..


    Hope that helps.


    Si