I have Dunlop DVP3. I do not know, haw connect it to Kemper.
I connected Mission, using TSR ans TS cable.
It works Ok.
But using TSR. In DVP 3 using exp input. I kemper using remote port 3. In Kempes system
I do not find way haw set it so, that it starts work. Haw must I set it on Kemper side?
Connecting Dunlop DVP 3
- TiParts
- Thread is marked as Resolved.
-
-
Pedals 1 and 2 connect to the back of the KPA.
Remote Pedal 1 = Pedal 3
Remote Pedal 2 = Pedal 4
Remote Pedal 3 = Pedal 5
Remote Pedal 4 = Pedal 6 -
That I understand. I have already deployd Mission pedal, using TRS cable (Mission input one --> Kemper remote Pedal 3) and TS (Mission input two --> Kemper remote Pedal 4).
That works.
When I connect by TRS cable DVP3 EXP -->
Kemper remote Pedal 5, select in Kemper system Pedal 5 = Type1/Type2 and function
Volume/Morhp/Waw, it does not work. Even don t show pedal in calibration.
What I do wrongly here? -
I use the Dunlop DVP3 exactly how you've described and it works perfectly.
Sorry if I'm stating the obvious, but have you tried a different TRS cable? And checked that the Dunlop pedal is working properly? -
Dunlop DVP3 vas invalid