just installed latest 5.1+ firmware after no update in 3 years or so and all my profiles now have the kind of distortion caused by a too hot output signal. What do I need to do to fix this?
I just turn the Kemper on and play I've never really looked at any of the settings and can't see anything obvious to adjust this.
Output after latest update
- six20aus
- Thread is marked as Resolved.
-
-
I'm think you need to start updating in the progression. You might have jumped the gun.
-
Updating directly to the current OS is not a problem.
Check your Input Settings. They may have been reset by the update. If you aren't sure how to set them for your guitar, there is a YouTube video from Kemper that explains how to do it.
-
thanks both for the replies i will check this out!!