Using Rig Manager 2.0.19 and latest firmware. Every time I launch Rig Manager my Kemper display says "Syncing Rig 0 of 104" and this takes about 2 full minutes, and then it goes back to normal. What would I check to see why it is always 104 Rigs and why doesn't it ever keep them synced?
[SOLVED] - Rig Manager Sync on Kemper After Every Launch
- SidestepStudios
- Thread is marked as Resolved.
-
There is more than one possible reason for this. It is not very probable, but it could be that these 109 rigs are damaged. Please start your Profiler while holding the RIG key pressed, so it will check all rigs and sort the damaged ones out. If that does not fix the problem, please contact support.
-
Thank you! This has corrected the issue. It no longer does the sync after this.
