I am sorry this has been asked before,
I am trying to turn all cab sims of globally so I don't need to keep switching them off on the front of my Kemper. I use a 4x12 v30 cab
Global Cabs
- sherpa_man
- Thread is marked as Resolved.
-
You can either lock the cab section after turning it off, or change a setting in the output section globally for the monitor out output.
-
You could enter the «cab» block, turn it off and then hit “lock”. Then it will be off until you unlock it. This will affect all outputs.
You could also go to the output section and turn off cab on the “monitor” output only. -
You could also go to the output section and turn off cab on the “monitor” output only.
This ^ if you're using the monitor out > amp > 4x12. You'll be covered 100%.
-
This ^ if you're using the monitor out > amp > 4x12. You'll be covered 100%.
This is also the best way to do this if you are using the Powered KPA Amplifier Output jack.
